6 precautions for precision parts processing

Precision parts processing is a very cautious processing technology, and because of this, some precautions are also necessary when carrying out this processing technology.

Our Dongguan Ruibang Technology specializes in CNC processing, hardware parts processing, precision parts processing, etc. There have been many years of technical accumulation. Processing products cover the fields of machinery, automation equipment, aviation, automobile, electronics, medical equipment, communication equipment, etc. The industries are spread across Guangzhou, Shenzhen, Dongguan, Pearl River Delta and other places. Let’s follow them to see 6 precautions for precision parts processing.

1. Before working the machine, check whether the moving part is filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine tool airborne for 1-3 minutes. It is strictly forbidden to operate if the machine has a fault;

2. Maintain the correct posture when working and have sufficient energy to deal with the work. If you find physical discomfort, you must leave your job immediately and report it to your leader. When operating, you must concentrate your mind, chatting and cooperating with each other. Operators must not operate in an irritable or tired state to avoid accidents and ensure safety in operation. All employees check whether their clothing meets work requirements before entering the job. Slippers, high heels or clothing that affects safety are not allowed. Those with long hair should wear safety helmets;

3. When replacing the mold, first turn off the power supply. Only after the punching machine movement department stops running can the mold be installed and debugged. After the installation and adjustment, move the flywheel with your hand to test and check whether the upper and lower molds are symmetrical and reasonable, whether the screws are strong, and whether the pressing ring is in a reasonable position;

4. You must wait until all other personnel leave the machine work area and take away the debris on the workbench before you can start the power supply and start the machine;

5. When working in machinery, it is prohibited to extend your hand into the slider work area, and it is strictly forbidden to use your hand to pick up or place the workpiece. Tools that meet standards must be used when picking and putting workpieces in the die. If you find abnormal sound in the machine or the machine fails, you should turn off the power switch immediately for inspection. After the machine is started, one person transports materials and operates them by the machinery. Others are not allowed to press the power building or step on the switch board, and they cannot put their hands into the mechanical work area or touch the moving parts of the machinery with their hands;

6. When you get off work, you should turn off the idle power supply and organize the finished products, side materials and debris at your post to ensure the clean and safe working environment.

The above are 6 precautions for Dongguan Ruibang Technology can produce products that are satisfactory to customers according to different customer requirements. Welcome to the picture to place an order.precision parts processing , for reference only.